Close
Subscribe to newsletters
Email:

L298 Dual H-Bridge Motor Driver - V2

Double H driver module uses ST L298N dual full-bridge driver, an integrated monolithic circuit in...

SKU: MOT01800762
Availability: 87 in stock
R 113,22
:

Description

Double H driver module uses ST L298N dual full-bridge driver, an integrated monolithic circuit in a 15- lead Multi watt and PowerSO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are provided to enable or disable the device independently of the input signals. The emitters of the lower transistors of each bridge are connected together and the corresponding external terminal can be used for the connection of an external sensing resistor. An additional supply input is provided so that the logic works at a lower voltage.

This module is integrated with a built-in 5V power.When the drive voltage is 7V-35V, it can enable the on-board 5V logic power supply.

ENA enable IN1 IN2 control OUT1 OUT2 
ENB enable IN3 IN4 control OUT3 OUT4

Features

  • Light weight, small dimension
  • Super driver capacity
  • FWD protection
  • Heavy load Heat sink
  • 2 current probe port
  • Power selection switch
  • 4 pull up resistor switch
  • 2 DC motor/ 4 coil dual phrase stepper motor output
  • Motor direction indication LED
  • 4 standard mounting holes
  • Driver: L298
  • Driver power supply: +5V~+46V
  • Driver Io: 2A
  • Logic power output Vss: +5~+7V (internal supply +5V)
  • Logic current: 0~36mA
  • Controlling level: Low -0.3V~1.5V, high: 2.3V~Vss
  • Enable signal level: Low -0.3V~1.5V, high: 2.3V~Vss
  • Maximum power: 25W (Temperature 75C)
  • Working temperature: -25C~+130C
  • Dimension: 60mm*54mm
  • Driver weight: ~48g